Tiger CNH T6010-80 Mounting And Operating Instructions page 36

ASSEMBLY
POLYCARBONATE SAFETY WINDOW
NOTE: Installing a boom mower requires that all of the right side windows be replaced, or
protected with a polycarbonate window. This should be done before mounting the main frame.
1. Disconnect gas shock at door. Remove the right side cab door/window glass from tractor cab
by removing hinge pins. Also, remove rear right side window.
2. Remove the existing hardware and discard factory glass door and window.
3. Place small bead of adhesive seal in the bottom of the trim lock bubble seal.
4. Install trim lock bubble seal on polycarbonate starting at the center bottom horizontal portion.
5. Install existing hardware removed from glass door and window on the polycarbonate.
6. Install the polycarbonate assembly in the cab with existing and supplied hardware.
7. Press polycarbonate into place at upper front corner
8. Drill a Ø3/16" pilot hole through polycarbonate and corner gusset of door jam.
9. Locate hole 1-1/4" from edge of the lower rounded feature of the corner gusset and center it
from each end. Then drill out hole in polycarbonate with a Ø15/32" bit that is only used for poly-
carbonate.
10. Drill out hole in gusset with Ø3/8" bit for steel.
11. Install the polycarbonate door into place where factory door wsa removed (upper right rear
first). Refer to the parts section for the details.
12. Install grommet into hole in polycarbonate. Install supplied 1/4" nut into corner gusset.
13. Secure upper right corner with supplied washer and capscrew. Refer to the Parts Section for
details.
(ASM-NH-0052)
Assembly Section 2-4