Tiger CNH T6010-80 Mounting And Operating Instructions page 45

LOAD SENSE HOSE ROUTING - OPEN CENTER
On a tractor with an Open Center system with Closed Center remotes, the lift valve uses the
Pressure, Return and Load Sense on the tractors rear remotes. The ports used are directly
under the valve mounting plate as shown below.
The Pressure hose is routed from the tractor remotes to the inlet port of the HP filter
on the valve mounting bracket. Then, the outlet port of the HP Filter to the pressure port
on the lift valve.
The Return hose runs from the return port of the lift valve to the tractor remotes.
The Load Sense line is routed from the load sense port of the lift valve to the load
sense port on the tractor rear remotes.
For more information refer to the Parts Section page for a complete diagram of the
tractor valve hookup.
LOAD
SENSE
RETURN
ASSEMBLY
(ASM-NH-0062)
Assembly Section 2-13
PRESSURE