Next Steps
To perform initial configuration through the BUI using any client on the same network, see
■
"Performing Initial Configuration (BUI)" on page
you select this method for initial configuration of clustered controllers.
To perform initial configuration through the CLI, see
■
(CLI)" on page
Performing Initial Configuration (BUI)
Use this procedure, which is a step-by-step utility, to complete initial configuration of network
interfaces, the Domain Name Service (DNS), time settings, name services, directory services,
storage, and remote support on the appliance. This procedure is for standalone and clustered
appliance configuration.
Note -
BUI for initial configuration.
For clustered controllers, configure only the primary controller. Do not attempt initial
configuration on both controllers independently. For more information about clustering, see
"Appliance Cluster Configuration" in Oracle ZFS Storage Appliance Administration Guide,
Release
Gather the following information for the interfaces and services you will set up, and
■
Before You Begin
network configuration details.
Note -
do not run NIS and LDAP at the same time.
■
■
■
■
■
■
■
■
145.
If you are installing clustered controllers, it is strongly recommended that you use the
OS8.6.0.
LDAP and NIS are optional for setup, but recommended. LDAP is preferred to NIS;
Default router IP address
IP address and netmask for the management interface (two if clustered controllers)
IP address and netmask for the data interface (two if clustered controllers)
DNS/NIS/LDAP domain name
DNS IP address(es)
NIS server IP address(es)
NTP server IP address
For LDAP:
LDAP server IP addresses
■
Performing Initial Configuration (BUI)
131. It is strongly recommended that
"Performing Initial Configuration
Configuring the Appliance for the First Time
131