Table of Contents
Advertisement
Powering Off a Disk Shelf
If a disk shelf is a part of a storage pool, powering off or removing all SAS chains from a disk
shelf will trigger a kernel panic on the controller(s) to prevent data loss, unless the shelf is part
of an NSPF (no single point of failure) data pool. To avoid this, shut down the controller(s)
before decommissioning the shelf, as described in
Place the power supply on/off switches to the "O" off position.
1.
2.
Disconnect the power cords from the external power source for the cabinet.
All power cords must be disconnected to completely remove power from the disk shelf.
Note -
Related Topics
"Powering Off a Controller" on page 124
■
"Powering On a DE2-24 Disk Shelf" on page 121
■
"Powering On a Sun Disk Shelf" on page 123
■
Powering Off a Disk Shelf
"Powering Off a Controller" on page
Powering On the Appliance
124.
125
Advertisement
Table of Contents
