Table of Contents
Advertisement
The slide rails can be used with either 9.5-mm square or M6 round mounting hole racks.
Note -
3.
(Optional) If installing the assembly with cage nuts and mounting screws, insert
the cage nuts into the front and rear rack posts in the desired positions. Then
insert the mounting screws through the front and rear slide-rail brackets and
rack posts.
Repeat Steps 2 and 3 for the other slide-rail assembly.
4.
Installing a ZS4-4 or ZS3-4 onto the Rack Slide Rails
Use the following procedure to install a ZS4-4 or ZS3-4 controller onto the rack slide rails.
This procedure requires a minimum of two people, or a mechanical lift, because of
Caution -
the weight of the chassis. Attempting this procedure alone could result in equipment damage or
personal injury. Always load the heaviest equipment (disk shelves) at the bottom of the rack.
Installing a ZS4-4 or ZS3-4 onto the Rack Slide Rails
Installing a ZS4-4 or ZS3-4 Controller
75
Advertisement
Table of Contents
