Table of Contents
Advertisement
Installation Overview
This guide describes installation procedures for the Oracle ZFS Storage Appliance.
Each controller should have at least one NIC port configured as a management interface.
If necessary, install additional NIC card(s) into the appropriate PCIe slot(s) before initial
controller installation. For information on installing a PCIe card, see the appropriate section for
your controller in the
Oracle ZFS Storage Appliance Customer Service
Follow these steps to install your appliance:
1. Read
"Prerequisites for Installation" on page
2. Review the information about your disk shelves and controllers in
Prerequisites and Hardware Overviews" on page
3. Install your disk shelves using the appropriate procedure in
Shelves" on page
57.
4. Install your controllers:
"Installing a ZS4-4 or ZS3-4 Controller" on page 73
■
"Installing a ZS3-2 Controller" on page 81
■
"Installing a 7x20 Controller" on page 99
■
5. Cable the appliance as described in
For the maximum number of disk shelves supported per controller configuration, see
"Maximum Disk Shelves per Controller" on page
6. Power on your appliance using the procedures in
Appliance" on page
7. Complete first-time configuration and prepare the appliance for production using the
procedures in
"Configuring the Appliance for the First Time" on page
For information about troubleshooting hardware faults using Oracle Integrated Lights Out
Manager (ILOM), see
"Troubleshooting Hardware Faults" on page
Getting Started with
121.
Manual.
11.
"Installation
11.
"Installing Disk
Cabling.
16.
"Powering On the
155.
Installation Overview
127.
9
Advertisement
Table of Contents
