Installing A Zs4-4 Or Zs3-4 Controller; Installing The Slide Rails Onto A Zs4-4 Or Zs3-4 - Oracle ZFS Installation Manual

Installing a ZS4-4 or ZS3-4 Controller

This section contains installation procedures for the ZS4-4 or ZS3-4 controller.
Before beginning installation, see
Overviews" on page
Use the following procedures to install a ZS4-4 or ZS3-4 controller:
"Installing the Slide Rails onto a ZS4-4 or ZS3-4" on page 73
■
"Installing the Slide Rails into the Rack for a ZS4-4 or ZS3-4" on page 74
■
"Installing a ZS4-4 or ZS3-4 onto the Rack Slide Rails" on page 75
■
"Installing a ZS4-4 or ZS3-4 Cable Management Arm" on page 77
■

Installing the Slide Rails onto a ZS4-4 or ZS3-4

Use the following procedure to install the slide rails onto a ZS4-4 or ZS3-4 controller.
The slide rails can be used with either 9.5-mm square or M6 round mounting hole racks.
Note -
1. Position a mounting bracket against the chassis so that the slide-rail lock is at
the front of the chassis, and the five keyed openings on the mounting bracket
are aligned with the five locating pins on the side of the chassis.
The mounting brackets are identical and can be installed on either side of the chassis.
Note -
"Installation Prerequisites and Hardware
11.
Installing a ZS4-4 or ZS3-4 Controller 73