Tools Required To Unpack And Install The Ptx3000 - Juniper PTX3000 Quick Start Manual

Figure 2: Four Routers Installed Back-to-Back
1 Upper chassis 1
—
2 Upper chassis 2
—

Tools Required to Unpack and Install the PTX3000

Gather the tools required to unpack the PTX3000:
Phillips (+) screwdriver, number 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
Gather the tools and parts required to install the PTX3000 in a rack:
Mechanical lift
Screwdriver appropriate for your mounting screws (a number 1 Phillips (+) screwdriver is required for
the mounting screws included in the accessory box
Mounting screws appropriate for your rack (ten mounting screws are included in the accessory box)
Cage nuts (if required for your rack or cabinet)
3 Lower chassis 1
—
4 Lower chassis 2
—
6