REMKO WLT EC Series Operating And Installation Instructions page 28

REMKO WLT EC series
Fig. 22: "TIME" key - Switch-off time
28
TIME-OFF
TIME-SET
TIME-OFF
"SLEEP" key
After the "SLEEP" key is pressed, the symbol is
shown on the display and the room temperature is
raised or lowered by 0.5 °C in cooling and heating
mode respectively 30 minutes after the function
starts up. After a further 30 minutes, the room tem-
perature is raised or lowered by 1 °C in cooling
and heating mode respectively. After a further hour,
the room temperature is held at a constant 2 °C
above or below the original target temperature in
cooling and heating modes respectively. This tem-
perature is then maintained at a constant level.
This function is disabled by pressing the "POWER"
or "SLEEP" key. The symbol on the display extin-
guishes.
Fig. 23: "SLEEP" key - Cooling mode
Fig. 24: "SLEEP" key - Heating mode
SLEEP
SLEEP
SLEEP
SLEEP