Operation - REMKO WLT EC Series Operating And Installation Instructions

REMKO WLT EC series
4

Operation

The unit has a variety of operating modes.
The infrared remote control provided by the factory
or the cabled remote control that is available as an
accessory can be used to operate up to 32 units
within a REMKO bus or individually.
At the same time, operation can be carried out via
an external controller with a three-stage fan speed,
via a room temperature controller that is available
as an accessory or via a controller that is provided
by the customer (e.g. CBCS).
Furthermore, the fan motor can be controlled virtu-
ally infinitely via an external 0 - 5V or 0 - 10V
signal.
The corresponding wiring diagrams can be found
in the separate operating manuals for the remote
control/regulation.
Help save on energy consumption in stand-by
mode! If the device, system or component is not
in use, we recommend disconnecting the power
supply. Components with a safety function is
excluded from our recommendation!
Example controls
n Single control with three-stage fan operation
via external regulation
GLT
1
1: Regulation provided by the customer
18
n Group control with three-stage fan operation
via external regulation
GLT
1
1: Regulation provided by the customer
2: Switching relay
n Single operation with five-stage fan operation
via IR or alternative cabled remote control
n Operation with an external 0 - 5/10V signal and
infinitely variable fan operation via external reg-
ulation
1
1: Regulation provided by the customer
n Control in REMKO network with five-stage fan
control and group operation on all slave units
Master
1 1
1: Alternative operation
2
Slave Slave
1