REMKO WLT EC Series Operating And Installation Instructions page 20

REMKO WLT EC series
Keys on the remote control
3
1
4
5
6
13
14
Fig. 6: Keys on the remote control
"POWER" key
1
Press this key to operate the unit.
"TEMP" key
2
Press this key to set the desired temperature in
1 °C steps within the range 16 °C to 30 °C.
"SLEEP" key
3
Pressing this key will automatically increase or
decrease the target temperature by 1 °C within an
hour in cooling mode and heating mode respec-
tively.
20
"MODE" key
4
Press this key to select the operating mode. The
indoor unit has 5 modes:
1. Automatic mode (COOL/HEAT):
In automatic mode, the temperature is maintained
at the constant setpoint.
2
2. Cooling mode (COOL):
7
In cooling mode, the warm room air is cooled to
the lower pre-set target temperature.
8
3. Dehumidification mode (DRY):
9
In this mode, the room is mainly dehumidified.
10
11
4. Recirculation mode (FAN):
12
In recirculation mode only the air is circulated. The
room temperature is not controlled.
5. Heating mode (HEAT):
In heating mode, the cold room air is heated to the
pre-set higher temperature.
"SWING" key
5
This key switches on the oscillating fins to provide
improved air distribution in the room. It can also be
used to lock the fins.
"FAN" key
6
Press this key to set the desired fan speed. 4
speeds are available: Automatic, high, medium
and low fan stage.
"TIME-ON" key
7
This key is used to program the automatic switch-
on function for the indoor unit.
"NETWORK" key
8
Use this key to transfer the data that was set to all
other units within a network.
"SILENT" key
9
Press this key to set a particularly low fan speed.
"TIME-OFF" key
10
This key is used to program the automatic switch-
off function for the indoor unit.