Related Manuals for REMKO RKL 300
Summary of Contents for REMKO RKL 300
- Page 1 Assembly and operating instructions REMKO RKL 300, RKL 300 S-Line, RKL 360, RKL 360 S-Line Local Air Conditioner Read the instructions prior to performing any task! 0058-2014-01 Edition 2, en_GB...
- Page 2 Read these operating instructions carefully before commis- sioning / using this device! These instructions are an integral part of the system and must always be kept near or on the device. Subject to modifications; No liability accepted for errors or mis- prints! Installation and operating instructions (translation of the orig- inal)
-
Page 3: Table Of Contents
Table of contents Safety and usage instructions......................4 1.1 General safety notes........................4 1.2 Identification of notes........................4 1.3 Personnel qualifications........................4 1.4 Dangers of failure to observe the safety notes................4 1.5 Safety-conscious working....................... 4 1.6 Safety notes for the operator......................5 1.7 Safety notes for installation, maintenance and inspection.............. -
Page 4: Safety And Usage Instructions
REMKO RKL Safety and usage CAUTION! instructions This combination of symbol and signal word 1.1 General safety notes warns of a potentially hazardous situation, which if not avoided may cause injury or mate- Carefully read the operating manual before com- rial and environmental damage. -
Page 5: Safety Notes For The Operator
"certificate of warranty" to conditions stipulated in this manual and comply REMKO GmbH & Co. KG at the time when the with all applicable regional regulations. units are purchased and commissioned. -
Page 6: Transport And Packaging
REMKO RKL 1.11 Transport and packaging The devices are supplied in a sturdy shipping con- tainer. Please check the equipment immediately upon delivery and note any damage or missing parts on the delivery and inform the shipper and your contractual partner. For later complaints can not be guaranteed. -
Page 7: Technical Data
Technical data 2.1 Unit data RKL 300 RKL 360 Series RKL 300 RKL 360 Operating mode Local compact air conditioning unit for cooling Nominal cooling output Energy efficiency ratio - cooling Energy efficiency rating EER Energy consumption, hourly kWh/60 min 1.13... -
Page 8: Design And Function
REMKO RKL Design and function Unit description The local air conditioning unit is particularly well suited to flexible use. The local room air conditioner comprises a floor- standing unit for the indoor area and an exhaust air hose to conduct the heat away. The indoor unit... -
Page 9: Operation
Operation The system can be operated by means of the control panel on the unit or via the standard infrared remote controller. The functional operation of the keys among themselves is identical, however, the designation can vary. The batteries must be correctly inserted before the infrared remote control is used. Fig. - Page 10 REMKO RKL "COMP. ON" key "DRAIN WATER" display Cooling capacity will now only be generated whilst The condensate arising will be collected in an the compressor is active. Upon reaching the pro- internal reservoir, fed to the condenser and evapo- grammed target temperature, the compressor and rated there.
- Page 11 Inserting the batteries into the remote control Before initial commissioning, insert the supplied batteries (2 each, type AAA) into the remote con- Help save on energy consumption in stand-by trol. mode! If the device, system or component is not in use, we recommend disconnecting the 1.
-
Page 12: Assembly And Installation
REMKO RKL Assembly and Check whether the stopper in the condensate drain is present and correctly installed. There is installation a risk of uncontrolled condensate leakage after commissioning. Assembly and unit installation instructions The unit is positioned at the desired location with the discharge side pointing into the room. - Page 13 Conduct the warm exhaust air away Via a wall pass-through The hose supplied is firmly attached to a wall pass- through. A suitable wall pass-through is available NOTICE! as an accessory (Fig. 12). The exhaust air hose should always be laid rising in the direction of air flow and must not be extended! In cooling mode the unit creates warm moist...
- Page 14 REMKO RKL Installation scheme for wall pass-though (accessory) Fig. 13: Installation example External grill Non-return flap Telescopic tube Sealing cover Installation instructions Create a core hole in the exterior wall (wall thickness 270-480 mm) with a diameter of at least 135 mm.
-
Page 15: Electrical Wiring
Electrical wiring Electrical drawings Fig. 14: Electrical drawings PCB1: Control panel MS1: Microswitch (tank full) PCB2: Control board MS2: Microswitch (pump) Swing motor Colour coding: Fan motor (evaporator) Black Fan motor (condenser) Brown Condensate pump Blue Compressor Grey OLP: Compressor fuse Orange CX1: Capacitor (M1) -
Page 16: Commissioning
REMKO RKL Commissioning Before every commissioning the air inlet and outlet openings should be checked for foreign bodies and the air inlet filter must be checked for dirt. Blocked or soiled grids and filters must be cleaned immedi- ately, see "Care and maintenance" chapter. -
Page 17: Troubleshooting And Customer Service
Troubleshooting and customer service The unit has been manufactured using state-of-the-art production methods and has been tested several times to ensure that it works properly. If malfunctions should occur, please check the unit as detailed in the list below. Please inform your dealer if the unit is still not working correctly after all the function checks have been performed. -
Page 18: Care And Maintenance
REMKO RKL Care and maintenance Filter cleaning The unit is equipped with two air filters. These can Regular care and observation of some basic points be withdrawn from the rear of the unit. The filters will ensure trouble-free operation and a long must be cleaned at regular intervals. -
Page 19: Shutdown
Permanent shutdown The entire system should only be dismantled by a specialist firm familiar with all environmental aspects involved. REMKO GmbH & Co. KG or your sales partner will be pleased to provide details of refrigerant specialists in your area. -
Page 20: Exploded View And Spare Parts Lists
REMKO RKL Exploded view and spare parts lists 11.1 Exploded view of the unit Fig. 18: Exploded view drawing We reserve the right to modify the dimensions and design as part of the ongoing technical development process. -
Page 21: Spare Parts List
Spare parts list For ordering spare parts, please contact directly to the REMKO GmbH & Co. KG. All their device the accompanying part numbers can be found in the download area on www.remko.de IMPORTANT! To ensure the correct delivery of spare parts, please always the device type with the corresponding serial number (see type plate) No. - Page 22 REMKO RKL No. Description RKL 300 RKL 300 RKL 360 RKL 360 Fan motor (evaporator) Evaporator housing Fan housing (evaporator) Fan impeller (evaporator) Fin motor Exhaust air filter Power supply with plug By request with the serial number Compressor capacitor...
-
Page 23: Index
Index Assembly............12 Recirculated air filter.......... 12 Care and maintenance........18 Safety Cleaning the filter..........18 Dangers of failure to observe the safety notes............... 4 Condensate drain..........12 General............4 Conduct the warm exhaust air away....13 Identification of notes........4 Notes for inspection........ - Page 24 REMKO RKL...
- Page 26 REMKO RKL...
- Page 28 SFlb Customer Service Our equipment operates precisely and reliably. However, in the event of a fault, REMKO customer service is quickly at the scene. Our comprehensive network of experienced dealers always guarantees quick and REMKO GmbH & Co. KG reliable service.