REMKO WLT EC Series Operating And Installation Instructions page 24

REMKO WLT EC series
"COOL" mode
Press the "MODE" key once or repeatedly to
switch to cooling mode. Use this mode to cool the
room air to the desired target temperature. Press
the "TEMP / " keys to set the desired room
temperature in 1 °C steps. If the room temperature
is 1 °C above the desired temperature and suffi-
cient coolant is available, the indoor unit will start
to cool the room air. If the temperature falls to
approx. 0.5 °C below the set room temperature,
the regulation will switch off cooling mode.
COOLING MODE KÜHLBETRIEB
Fig. 13: "COOL" mode
24
MODE
MODE
"DRY" mode
Press the "MODE" key once or repeatedly to
switch to dehumidification mode. Use this mode to
dehumidify the room in an unregulated fashion.
After pressing the "DRY" key, select the desired
temperature and fin position. It is not possible to
set the fan speed. The fan is switched off at certain
intervals to lower the temperature at the cooling
battery. The low temperature causes the air tem-
perature at the fins to fall below the dew point.
Excess humidity in the air condenses on the
cooling battery and the room is dehumidified.
DEHUMIDIFICATION MODE ENTFEUCHTUNGSBETRIEB
Fig. 14: "DRY" mode
MODE
MODE