REMKO WLT EC Series Operating And Installation Instructions page 33

Mounting plates
The following figures show the mounting plates when installed, as well as the route of the medium piping
installed on the unit (shaded in blue). The centre point marked on the mounting plate is also the centre point
of the unit. The hole for the medium piping can be arbitrarily located on the left or right and should have a
minimum diameter of 65 mm.
TO UNIT LEFT EDGE
186,5 mm
A
100 mm
B
100,00 mm
C
100,00 mm
Fig. 29: Mounting plates
A: WLT 30 EC - WLT 40 EC
B: WLT 50 EC - WLT 60 EC
C: WLT 80 EC - WLT 90 EC
TO UNIT UPPER EDGE
TO CENTER OF PIPING
100 mm
100 mm
UNIT CENTER LINE
TO UNIT RIGHT EDGE
LEVEL LINE
TO CENTER OF PIPING
186,5 mm
100 mm
100 mm
100 mm
100,00 mm
100,00 mm
33