Command Line - Martin Maxxyz User Manual

Amount * "x"
PT Comb
C L
OMMAND
The Maxxyz console uses a command line display that displays the keys pressed to construct a
command. At any point during the construction of the command, you may press the back arrow
key found on the Keypad Entry to "backspace" over commands and edit them. Once the
command has been constructed and executed, it can no longer be edited but it remains on the
command line in a "grayed out" state until the next command is started.
The command line (outlined in red below) appears at the bottom of several of the playback
screens including Cuelist, Playback, Presets, Programmer, and Groups. The command line is a
useful tool in keeping track of the commands you have been entering as well as showing the
mode (Live, Blind or Patch) that the console is currently in. It is recommended that if the console
is not behaving in the manner you anticipate that you first check the command line before
pursuing other alternatives.
At the far right hand side of the command line is a button labeled and "Esc" (escape). Pressing
the escape key can be used to clear the entire command line.
62
This box can be changed from "Amount *1" through "Amount
*5" in steps of one. It is used in the creation of effects and is
covered in "The "Amount * 1" Button" on page 171.
This is an abbreviation for "Pan/Tilt Combine" and will be
discussed later in the Effects section of the manual
(page 166).
INE
Maxxyz