Page 1
M2GO/M2PC™ Controller Replacing Dongle with the new Dongle type Symptom When the M2GO/M2GO dongle has to be replaced with a new dongle type, an adapter PCB is used. Solution Follow these instructions to replace the Dongle. Tools needed Torx T-10 screw driver.
Page 2
Remove 4 screws from the back side (orange arrows) Loosen the 2 scews marked with the blue arrows. www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark Tel. (+45) 8740 0000 • Fax (+45) 8740 0010...
Page 3
4. Remove the cable adapter PCB from the front panel PCB by pulling it out of its sockets. Don’t unplug the cabling. www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark Tel. (+45) 8740 0000 • Fax (+45) 8740 0010...
Page 4
The connector of the adapter PCB must face up, and the serial label on the dongle must face down. www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark Tel. (+45) 8740 0000 • Fax (+45) 8740 0010...
Page 5
10. Put the front panel back on the bottom housing. Warning: Make sure that no cables are pinched between front panel and bottom housing. www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark Tel. (+45) 8740 0000 • Fax (+45) 8740 0010...
Page 6
12. Check the “LIVE” status in the lower left corner of the screen. 13. Close the controller by putting the screws back in place. www.martin.com • Olof Palmes Allé 18 • DK-8200 Aarhus N • Denmark Tel. (+45) 8740 0000 • Fax (+45) 8740 0010...