Table of Contents
Advertisement
• Martin fixtures introduced before 1997 have reversed polarity data sockets (pin 2 + and pin 3 -).
The socket polarity is labelled. Use a phase-reversing cable between the Maxxyz and any device
with reversed polarity.
C
O N N E C T I N G T H E
1 Using the proper cable, connect the DMX device to the Maxxyz's 5-pin output (female)
connector.
2 Insert a male 120 Ω XLR termination plug in the 3-pin or 5-pin output of the last device on the link
if required.
AC
POWER
WARNING! For protection from electric shock, the console must be grounded (earthed). The
AC mains supply shall be fitted with a fuse or circuit breaker and ground-fault
protection.
P
O W E R S U P P L Y
The Maxxyz comes with an auto-sensing, auto-ranging switch-mode power supply. Manual
adjustments to the mains voltage and frequency are not necessary as the Maxxyz automatically
adapts.
P
O W E R C O N N E C T I O N
Important! Connect the Maxxyz directly to AC power. Do not connect it to a dimmer system;
doing so may damage the console.
You may need to install a cord cap that fits your supply on the power cable. A 3-prong
grounding-type plug must be installed following the manufacturer's instructions. The table below
shows some possible pin identification schemes; if the pins are not clearly identified, or if you
have any doubts about proper installation, consult a qualified electrician.
To apply power, set the power switch on the rear of the console to the "I" position.
14
D M X
L I N K
Wire Color
Pin
brown
live
blue
neutral
yellow/green
ground
Symbol
L
N
Maxxyz
Screw (US)
yellow or brass
silver
green
Advertisement
Table of Contents
