Table of Contents
Advertisement
6.1.5
"Temperatures" Group
The "Temperatures" group indicates the status of the existing temperature sensors (device-
dependent).
The temperature will be displayed in a thermometer symbol, depending on the view.
• The unit is °C (Celsius) for metric settings
• The unit is °F (Fahrenheit) for Anglo-American settings
Proceed as follows to change this setting:
1. Start the country setting in the Control Panel.
2. You select the measuring system in the "Numbers" tab under "Measuring system."
3. Re-start Management Explorer.
The last temperature measurement is displayed below the thermometer symbol. To the left
of the temperature scale are the minimum and maximum allowed values. Violation of these
limits will trigger an alarm. To the right of the temperature scale are the minimum and
maximum measured values.
Alarms
If the temperature exceeds or falls below the specified maximum or minimum value, this is
displayed in the status of the sensor (see Display of Alarms (Page 22) ).
6.1.6
"Fan" Group
The "fan" group indicates the status of the existing fans (device-dependent).
The fan speed is represented in a fan symbol, depending on the selected view; all speeds are
indicated in revolutions per minute. The last speed measurement is displayed below the fan
symbol. To the left of the speed scale are the minimum and maximum allowed values.
Violation of these limits will trigger an alarm. To the right of the speed scale are the minimum
and maximum measured values.
Alarms
If the speed falls below the indicated minimum value, such a reaction will be displayed in the
sensor status (see Display of Alarms (Page 22)).
SIMATIC IPC DiagMonitor V5.1.6
Operating Manual, 05/2021, A5E50981422-AA
Displaying operating data and alarms
6.1 The Management Explorer
19
Advertisement
Table of Contents
