PG 760 PII Expansions
4.5
Installing and Removing Disk Drives
Installing and
The floppy disk drive is installed on the front of the unit. If necessary, you
Removing Floppy
can replace it with another.
Disk Drives
Figure 4-6
Installation of
To install or remove the disk drive, proceed as follows:
Floppy Disk Drives
1. Turn off the unit and unplug the power cable.
2. Open the unit as described in Section 4.1.
3. Unplug the connecting cable from the disk drive.
4. Loosen the screws on top of the disk drive support.
5. Pull the disk drive backwards out of the disk drive support.
6. To install disk drives, follow the above procedure in reverse.
7. Close the unit (see Section 4.7).
4-12
Floppy disk drive
Location of the Floppy Disk Drive
Locking screws
PG 760 PII Programming Device
C79000-G7076-C766-01