Siemens SIMATIC PG 760 PII Manual page 64

Configuring the PG 760 PII
Option "Boot
The following submenu appears when you select the option "Boot Options"
Options" in the main menu:
Figure 5-5
Quick Boot
Mode
SETUP prompt
POST Errors
Floppy check
Summary screen
Boot Sequence
5-10
PhoenixBIOS Setup-Utility
Main Advanced Security
Boot Options
[Enabled]
QuickBoot Mode:
SETUP prompt: [Enabled]
POST Errors: [Enabled]
Floppy check: [Disabled]
Summary screen: [Enabled]
Boot Sequence:
1. [Diskette Drive]
2. [Removable Devices]
3. [Hard Drive]
4. [ATAPI CD-ROM Drive]
Hard Drive Boot Device
Diskette Boot Device
F1 Help Select Item + / –
ESC Exit Select Menu Enter Select
"Boot Options" Submenu
Allows the system to skip certain tests while booting. This will
decrease the time needed to boot the system.
During the system loading phase, the following SETUP prompt is
output at the bottom of the screen: PRESS <F2> to enter Setup.
The loading procedure is aborted if an error is detected during the
system loading phase.
During the system loading phase, the floppy head is moved by a
number of steppings to the inside, and then returned again. This
test is useful because the drive is initialized again in the process.
The most important system parameters are output on the display at
the end of the system loading phase.
Here you can define the device sequence from which a system start
(boot attempt) is to be carried out first.
Removable devices:
Power Exit
Item Specific Help
Allows the system to skip cer-
tain tests while booting. This
will decrease the time needed
to boot the system.
Change Values F9 Setup Defaults
Sub-Menu F10 Save and Exit
allows to designate future ATAPI
drives such as LS120, for instance.
PG 760 PII Programming Device
C79000-G7076-C766-01