Table of Contents
Advertisement
System Unit
1.3.6
Removing and Installing Hard Disk Drives (Back)
Procedure
Proceed as follows to replace or install hard drives:
Figure 1-8
1-12
You can install a hard disk drive in the support located at the back of your
PC.
The support is mounted with six screws (see Figure 1-8). Five of them are
directly accessible at the back of the system unit. The third screw can only
be reached inside the unit from the top. The hard disk drives must be fixed
with screws at the upper and lower end of the support.
Then connect the installed hard disk drives, CPU board and power supply
by plugging in the corresponding connecting cables. Lay the cables so
that the drive can move freely.
mounting screws
Removing and Installing Hard Disk Drives
RI 45 PIII, Manual
C79000-G7076-C817-01
Advertisement
Table of Contents
