Siemens SIMATIC PG 760 PII Manual page 27

Connecting a
You can connect a serial mouse to the COM2 serial port. To operate a serial
Serial Mouse mouse, the appropriate mouse driver must be initialized and assigned
parameters. You will find the information you need to do this in the
description of your mouse or in the description of the operating system.
Proceed as follows:
1. Switch off your PG 760 PII.
2. Plug the serial mouse into the connector labeled COM2.
3. Switch on your PG 760 PII again.
Recommended You can connect external multisynchronous monitors using the standard
Monitors
VGA connector on the rear panel of the unit. We recommend that you use
Siemens monitors.
Connecting
You must switch off the PG 760 PII before connecting the monitor cable. You
Monitors
will find further information about the connector pinout in Chapter 7.
Figure 3-3 Connection to Monitor
Connect the monitor as follows:
1. Switch off the PG 760 PII and the monitor.
2. Plug the monitor cable into the VGA socket.
3. Plug the other end of the monitor cable into the monitor.
For technical specifications on the graphics interface, please refer to the
Product Information Bulletin.
Caution
!
Danger of damaging the monitor!
If you want to set higher frequencies and resolutions, first make sure that the
monitor you are using is suitable for a higher frequency and resolution.
If the frequency is too high, this may damage the monitor.
PG 760 PII Programming Device
C79000-G7076-C766-01
Installing and Operating the PG 760 PII
VGA socket for monitor
3-5