Siemens SIMATIC PG 760 PII Manual page 62

Configuring the PG 760 PII
Option " Multi-Sector
The number of sectors which are transmitted per interrupt are transferred in
Transfers" the option "Multi-Sector Transfers." The value depends on the drive and
should only be set using the autodetect function.
Disabled
2,4,6,8,16
Option " LBA Mode
"Enabled" in the option "LBA Mode Control" (enabled, disabled) means that
Control"
hard disk capacities greater than 528 MB are supported. The value depends
on the drive and should only be set using the autodetect function.
Option " 32 Bit I/O"
The type of access to the drive is defined in the option "32 Bit I/O":
Disabled
Enabled
Option " Transfer
The interface transmission rate is set in the option "Transfer Mode." The
Mode" or Ultra DMA
value depends on the drive and should only be set using the autodetect
Mode
function.
You leave the submenu using the ESC key.
5-8
sectors
16-bit access
32-bit access
PG 760 PII Programming Device
C79000-G7076-C766-01