Table of Contents
Advertisement
Error Diagnostics
Table 6-1 Errors/Faults in PG Operation
Error
Power on LED does not light up
Power on LED is illuminated in
red
Message:
"Invalid configuration
information.... Press F1 to resume,
F2 to Setup"
Message:
"No boot device available"
Booting of the PG aborted after
several beeps
Every time a key is pressed, a beep
is heard and no characters appear
Not-ready message when trying to
read a diskette
Write-protect error when trying to
write to a diskette
Message:
"EPROM TSR Interface disabled,
check Power Management"
Interface ports COM1, COM2,
LPT1 or MPI are not responding
<\> key inscription missing
<\>key not displayed
Mouse does not function
Mouse pointer cannot be moved
with the trackball
Mouse pointer moving erratically
Disk drive cover will not open
6-2
Cause
PG is switched off
Power supply not properly
connected
Device is in standby mode
Incorrect configuration data
Back-up battery is flat/does not
work
Diskette in drive A: is not a boot
diskette
Wrong hard disk type entered in
SETUP
An error has occurred during the
system self-test
Keyboard buffer overflow
No diskette has been inserted
Diskette has not been formatted
Diskette write-protect activated
Write-protect hole open on
3.5 in. diskette
Programming Interface in the
SETUP program is set on
disabled
Interfaces are disabled in
SETUP program
Not original keyboard
Wrong keyboard driver is being
used
The PS/2 interface is set to
disable
Trackball will not rotate
No/wrong mouse driver
Trackball dirty
Filter cover incorrectly fitted
Remedy
Press the mains switch on the
power supply unit
Check power supply
connections, power cable and
power plug
Press the On/Off switch on the
front of the device
Press F2, check the configuration
data in SETUP, if necesssary,
enter the default values, and
check error messages in the first
SETUP menu
Insert boot diskette
Use "Autodetected Fixed Disk"
function
Use "Fixed Disk Function" in
SETUP program
Check hardware
<CTRL> <PAUSE>
Insert diskette
Format diskette
Cancel write protection
Go to submenu PG 760 PII
Hardware Options in the
SETUP program and set the
Programming interface to
enabled
Go to submenu PG 760 PII
Hardware Options in the
SETUP program and set the
COM1, COM2, LPT1 and MPI
to enabled.
With German keyboard driver:
<ALTGr> <ß>, or
<ALT> <9> <2>
With international keyboard
driver:
<ALT> <9> <2>
Load correct keyboard driver
<ALT> <9> <2>
Check setup entry
Clean trackball and housing
Load the right mouse driver
Clean trackball and housing
Press on filter cover
PG 760 PII Programming Device
C79000-G7076-C766-01
Advertisement
Table of Contents
