Table of Contents
Advertisement
Hardware Information
Rear of the Drive,
The drive is configured as a Single. If you want to operate a second drive on this
Configuration
bus, you have to set either one of them as Master and the other as Slave or vice
versa.
SINGLE
7
7
Ground Terminal
Connect a ground cable with a flat pin connector (as used in cars) to this ground
terminal.
8
Jumper Block A
This block of jumper locations sets the configuration for the CD-ROM reader.
(See figure "Configuration" for details).
9
DIGITAL OUT
Connect a cable to this output to transfer Digital Audio data to appropriate audio
Connector
devices.
10 Line Out
Connect a cable to this output to transfer analog Audio data.
Connector
11 Jumper Block B
This block of jumper locations sets the configuration for the CD-ROM drive.
(See figure "Configuration" for details.)
Figure 7-17
12 I/O-Bus
This BUS connector is used to connect a data/control line. Use a flat ribbon cable
Connector
to connect your CD-ROM drive to the IDE controller.
13 Power
Connect the power supply cable to this connector.
Connector
7-20
FACTORY USE ONLY
DIGITAL
LINE
OUT
OUT
JUMPER
BLOCK
DIG GND
R GND L
1 2 3
8
9
10
11
A
B
1 2 3
1 2
Configuration
I/O BUS
12
Jumper Block A
1
Single
3
2
Factory use only
3
Factory use only
Jumper Block B
1
CSEL (for further extensions)
2
Slave
3
Master
PG 760 PII Programming Device
C79000-G7076-C766-01
+5V
GND
+12V
13
Advertisement
Table of Contents
