Automatic Control Functions; Foam Detection; Overflow Protection System; Dynamic Quantity Control - Hanseatic HWM 614 A3IT User Manual

Page GB-22

Automatic control functions

Automatic control functions
The following functions run automatically. You
cannot change them.

Foam detection

The electronic foam detection makes sure
that more water is added to the first rinse cy-
cle for certain amounts of foam.

Overflow protection system

This system prevents the water from leaking
out over the dispensing drawer (1). As soon
as a certain water level is exceeded, the out-
let pump will automatically switch on.

Dynamic quantity control

If the appliance is only half-loaded or loaded
with less laundry than the highest capacity,
the consumption of water and cycle duration
reduce for certain cycles. This helps you save
energy.

Imbalance correction system

This system protects the appliance in the
event of an imbalance that is too large when
spinning starts. This can happen with small
loads or with large individual pieces of laun-
dry. The laundry is distributed again and the
spin speed increased if the laundry distribu-
tion is right.