Interrupting/Changing The Cycle; Cycle End; Automatic Control Functions - Hanseatic HWMK814A User Manual

Interrupting/changing the cycle

1. To interrupt the current cycle or select an-
other cycle, switch off the appliance with
the button (5).
The cycle will be ended.
2. Set the cycle selector (2) to any other cy-
cle in order to drain the suds.
The suds will be drained away.
3. To select a new cycle, set the cycle selec-
tor (2) to a new cycle.
4. If required, add extra detergent.
5. Start the new cycle with the

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished. The display (3)
end
shows and the symbol disappears.
1. Open the loading door (14) and remove
the laundry.
2. Leave the loading door (14) open and pull
the dispensing drawer (1) out slightly to
allow the inside of the appliance to dry.
3. To switch off the appliance, press the
button (5).
If no further setting is made, the appliance
will automatically switch off after 15 minutes.
4. Turn the tap off.
5. Disconnect the mains plug from the socket.
Operation: Standard cycles

Automatic control functions

The following functions run automatically. You
cannot change them.
Foam detection
The electronic foam detection makes sure
that more water is added to the first rinse cy-
cle for certain amounts of foam.
Overflow protection system
button (6).
This system prevents the water from leaking
out over the dispensing drawer. As soon as
a certain water level is exceeded, the outlet
pump will automatically switch on.
Dynamic quantity control
If your appliance is loaded only up to half of
the maximum capacity, the water consump-
tion and cycle duration will reduce for certain
cycles. Adjust the detergent dosage accord-
ingly.
The
The cycle starts as soon as the appliance has
determined the amount of laundry (approx.
1 minute).
Imbalance correction system
This system protects your appliance in the
event of a too-great imbalance once spinning
starts. This can happen with small loads or
with large individual pieces of laundry. The
laundry is distributed again and the spin
speed increased if the laundry distribution is
right.
symbol lights up.
Page EN-21