First Steps; Selecting The Cycle; Adjusting The Temperature - Hanseatic HWM 614 A3IT User Manual

First steps

Requirements
– You have read chapter "Safety" and under-
stand all the safety instructions.
– The appliance is prepared as described in
chapter "Start-up" on page GB-27.
1. Check whether the water inlet hose (a) and
water outlet hose (13) are sitting securely.
2. Open the valve completely.
3. Make sure that the drum is empty.
4. Load the laundry that has been sorted
through into the drum.
5. Push the loading door (7) closed tightly.
6. Dispense washing detergent and fab-
ric-care products.
7. Set the cycle selector (2) to the desired
cycle. The appliance switches on. Signals
light up on the display (3).

Selecting the cycle

Off
Extra short 15'
Short 60'
Shirts
Mixed
Sports
Hand-/
delicate wash
Spin
Allergy
(2)
Duration of cycle (min.)
Wash step
Signal
0000 0
240
°C °
• Set the cycle selector (2) to the desired
cycle.
The display (3) shows the cycle duration.
The wash step signal and Start/Pause
signal are flashing.
Cotton
Signal Functions
0 0000
Cotton
Cotton
° °C
Eco 20°C
Start time Anti- Start
Easy care Temp. Spin preselection crease Pause
60°C
Wool
40°C
Rinse
Start/Pause
Functions
Standard cycles

Adjusting the temperature

You can adjust the temperature for most
cycles.
Signal
0 0000
90C
°C °
Start time
Temp. Spin preselection
60°C
40°C
(17)
1. Press the 'Temp.' (17) sensor button.
The temperature at which the cycle runs
as standard will appear on the display. You
now have 3 seconds to set the desired
temperature.
2. Press the 'Temp.' sensor button again, sev-
eral times if necessary.
The temperature setting reduces in steps
of 10 °C.
Signal
0000 0 --C
°C °
Start time
Temp. Spin preselection
60°C
40°C
After ' ' or ' ' the next step is '
30 C 20 C
If you have selected the setting '
wash will be without heated water (cold
wash).
You can undo the temperature setting
by
• pressing the 'Temp.' (17) sensor button
enough times that the original tempera-
ture setting is displayed again.
• positioning the cycle selector (2) in the
'Off' position and re-setting the
Page GB-17
Functions
Anti- Start
crease Pause
Functions
Anti- Start
crease Pause
'.
-- C
', the
-- C
cycle.