Hanseatic HWM 614 A3IT User Manual page 74

Page GB-34 Troubleshooting table
Problem
Detergent residue on
laundry.
Colours of the laundry
have faded.
Problem
Appliance does not
work.
Wash cycle does not
start.
Appliance is not
receiving water.
Water is not being
pumped.
Water is draining even
though the appliance
is not pumping.
Wash result is not satisfactory
Possible causes
Too much detergent used.
Detergent contains bleaching
agent.
Stain remover or similar was
used.
Malfunction
Possible causes
Mains plug is not sitting properly in
the socket or is not plugged in.
Socket has no voltage.
Fuse is not intact.
No wash cycle set.
Door is not closed properly.
Cycle was not started.
Valve is closed.
Door is not closed properly.
Inlet hose is bent.
Inlet hose is clogged.
Filter on inlet is clogged.
Outlet hose is clogged or bent.
Outlet hose is too low.
Solutions, tips
Wash laundry with the correct
dosage of detergent.
Use colour freshener if necessary
(available at chemist's). In future,
use detergent without bleaching
agent.
Solutions, tips
Plug the mains plug into the
socket properly.
Check fuse; switch on if
necessary.
Replace fuse.
Set wash cycle.
Close door properly.
(A 'click' must be heard).
Press 'Start/Pause' (4).
Open valve.
Close door properly.
Check inlet hose; dismantle if
necessary and re-align.
Clean filter on the inlet hose (see
page GB-24).
Clean filter on inlet (see page
GB-24).
Check outlet hose; dismantle if
necessary and re-align.
Place outlet hose higher.