Button Lock (Child Lock - Hanseatic HWM 614 A3IT User Manual

Button lock (child lock)

The button lock allows you to secure the ap-
pliance from unwanted use of the buttons.
You cannot activate the button lock if the cy-
cle selector is on 'Off'.
Signal
0 0000
240
° °C
Start time
Temp. Spin preselection
60°C
40°C
(19)
• To activate the button lock, press both
'Start time preselection' (19) and 'An-
ti-crease' (20) sensor buttons at the same
time for longer than 3 seconds.
Functions
Anti- Start
crease Pause
(20)
Functions
Signal
0 CL 0000
°C °
Start time
Temp. Spin preselection
60°C
40°C
The flashing ' ' signal will appear for a few
CL
seconds on the display (3). After that, the pre-
vious signal will be shown.
If you now press any sensor button, or turn
the cycle selector (2), only the flashing signal
' ' will appear.
CL
To deactivate the button lock, hold both sen-
sor buttons 'Start time preselection' (19) and
'Anti-crease' (20) down at the same time until
' ' flashes 8 times in a row and the original
CL
signal can be seen on the display once again.
Page GB-21
Functions
Anti- Start
crease Pause