Adjusting The Spin Speed; Starting The Cycle; Suspending And Continuing The Cycle - Hanseatic HWM 614 A3IT User Manual

Page GB-18 Standard cycles

Adjusting the spin speed

You can adjust the spin speed for most cy-
cles.
Signal
0000 0
I400
° °C
Start time
Temp. Spin preselection
60°C
40°C
(18)
1. Press the 'Spin' (18) sensor button.
The spin speed at which the cycle runs as
standard will appear on the display (3). You
now have 3 seconds to set the desired spin
speed.
2. Press the 'Spin' sensor button again, sev-
eral times if necessary.
The spin speed reduces in steps of 200
rotations.
Signal
0000 0 --
° °C
Start time
Temp. Spin preselection
60°C
40°C
After '400', the next step is '--'.
The spin function has now been switched
off. Select this setting if you do not wish the
laundry to be spun at the end of the cycle.
You can undo adjustments to the spin
speed by
• pressing the 'Spin' (18) sensor button
enough times that the original spin speed
is displayed again.
• turning the cycle selector (2) to the 'Off'
position and re-setting the cycle.
Functions
Anti- Start
crease Pause
Functions
Anti- Start
crease Pause

Starting the cycle

Signal
0000 0
240
° °C
Start time
Temp. Spin preselection
60°C
40°C
• Press the 'Start/Pause' (4) sensor button.
The wash cycle begins. The display
shows the remaining cycle time as well as
the progress of the wash cycle:
– Wash
– Rinse
– Spin.
Once the cycle has finished, the word 'End'
will appear on the display.
Suspending and continuing
the cycle
Please note that a long pause can affect the
wash result, as the suds cool down.
Signal
0000 0
240
°C °
Start time
Temp. Spin preselection
60°C
40°C
• Press the 'Start/Pause' sensor button (4)
to stop the running cycle.
The display will flash for as long as the
cycle is suspended.
• To continue, press the 'Spin' sensor but-
ton again.
Functions
Anti- Start
crease Pause
(4)
Functions
Anti- Start
crease Pause
(4)