Table of Contents
Advertisement
Available languages
Available languages
Page EN-26
Operation: Additional functions
Operation: Additional functions
Start time pre-selection
The cycle usually starts as soon as you have
pressed the
button (6). This appliance also
offers you the option to delay the start time.
Setting the start time preselection
3 Sek. drücken für Individuell/Signal
1 h
Startzeit
Zeit
sparen Temp/
U/Min/ Funktion
-Vorwahl
w
w w
(13)
The start time delay can be set in one-hour
increments. The maximum start time pre-se-
lection is 24 hours.
1. Select the desired cycle using the cycle
selector (2).
2. Press the "Start time preselection" but-
ton (13).
The
symbol and the delay time
appear on the display. This means that the
selected cycle will start in one hour.
3. To extend the delay time, repeatedly
press the "Start time preselection" but-
ton (13) until the display shows the de-
sired delay time.
4. Press the
button (6).
The cycle will start after the delay setting
has elapsed.
Terminate delay
If the
button (6) has
• already been pressed:
switch the appliance off using the
ton (5) .
• not yet been pressed:
repeatedly press the "Start time preselec-
tion" button (13) until
display.
Verschmutzungs-
Ein/Aus
Start/Pause
3 Sek. Tür
Entriegelung
1 h
will
but-
0 h
is shown on the
Button lock/Child lock
3 Sek. drücken für Individuell/Signal
Startzeit
Zeit
sparen Temp/
U/Min/ Funktion
-Vorwahl
(10)
The button lock allows you to secure the
appliance from unwanted use. This stops a
standard cycle from being altered when not
desired and from being accidentally started
or stopped. To
• activate the button lock, hold and press
both the "rpm/
/
" (10) and "Function" (9)
buttons at the same time until the
bol appears on the display and
All operating controls are locked (excep-
tion:
button (5)).
• switch the button lock off,
press and hold both the "rpm/
"Function" (9) buttons at the same time un-
CL
til the
symbol and
Switching beeps on/off
3 Sek. drücken für Individuell/Signal
Startzeit
-Vorwahl sparen Temp/
U/Min/ Funktion
(11)
You can decide whether or not there should
be a beep when a button is pressed and
when the cycle ends.
• To change the current setting, press and
hold the "Temp/
/
" button (11) for 3 sec-
onds.
Verschmutzungs-
grad
Ein/Aus
Start/Pause
3 Sek. Tür
Entriegelung
(9)
sym-
CL
flashes.
/
" (10) and
disappear.
Verschmutzungs-
grad
Ein/Aus
Start/Pause
3 Sek. Tür
Entriegelung
Advertisement
Chapters
Table of Contents
