Electrolux TWSL6IE300 User Manual page 28

28 www.electrolux.com
Problem
Unsatisfactory
drying result.
The loading
door does not
close
Not possible to
change the
program or op‐
tion.
Not possible to
select an op‐
tion. Acoustic
signal is emit‐
ted.
No drum light
Unexpected
duration time
on the display.
Program inac‐
tive.
Possible cause
1)
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
Iron Dry .
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After cycle start it is not possible
to change the program or option.
The option you tried to select is
not available for the selected
program.
Defective drum lamp.
The drying duration is calculated
according to load size and
dampness.
The water container is full.
Remedy
Select a suitable program.
3)
Clean the filter.
Change Dryness Level option to
higher level.
Do not exceed the maximum
load size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi‐
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option
as required.
Turn the tumble dryer off and on.
Change the program or option
as required.
Contact the service centre to re‐
place the drum lamp.
This is automated — the appli‐
ance is working correctly.
Drain the water container, push
the Start/Pause button.
2)
4)
3)
3)