Electrolux TWSL6IE300 User Manual page 21

11.7 Starting a program
To start the program, Touch the Start/
Pause button.
The appliance starts and the LED above
the button stops flashing and stays on.
On the screen you can find:
• the name of the program.
• the remaining drying time.
• the progress bar.
• the phase of a cycle (drying,
anticrease, cooling).
• the possible end time of the program.
Cottons
1h20min
Drying
Finished at 15:18
Child lock option activation:
At any time during the drying you can
activate the child lock option.
1. Tap on the option
the option list.
2. Tap on the child lock
The option icon will change into the
child lock icon.
Cottons
1h20min
Drying
Finished at 15:18
icon to get to
option.
To deactivate the child lock option tap on
and hold the child lock
seconds.
11.8 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
11.9 Program end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
0 appears on the display. If the
End Buzzer option is activated, the
acoustic signal sounds intermittently for 1
minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Laundry can
be removed during this
phase.
At the end of the anti-crease
phase the display tells that
the anti-crease phase is
finished and shows 0h00min
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
ENGLISH 21
icon a few
Cycle