Table of Contents
Advertisement
*EC 4004 ENGL.
14.12.1999 9:59 Uhr
5.2.3 Channel settings
New channels which are not part of the preprogrammation can be readily added.
As soon as you modify the channel settings, the table identification changes from "F" to "H".
Only when you have memorized the modifications by pressing
Important: Numerical entries only become valid, when the screen returns to channel display.
Only then are you allowed to make further entries. When repeatedly pressing the
same key, for example the sound channel key
breaks.
5.2.3.1 Video settings
>
Pressing the
There are two ways to enter new receive frequencies :
>
enter them directly with the numerical keys
>
or pressg
to increase or decrease the value
When holding the
steps followed by 5 MHz increments, after 10 changes.
Improper entries via the ten-key keypad will be acknowledged by the error message "Err".
You can set the video level by pressing the
sponding satellite types are listed in chapter 6.1, satellite types.
MEM
•
Press the
key to memorize your settings and, if necessary, enter a new channel number.
5.2.3.2 PAL audio settings
Select the PAL channel whose audio settings you want to modify.
>
press
A/B
until the desired sound channel is displayed.
>
Use the numerical keys or the
>
To receive in stereo press
Seite 19
key, the display shows the receive frequency in MHz (950 to 2050).
keys depressed, the frequency changes continuously, starting at 1 MHz
keys to set the new audio frequency.
A/B
,
MEM
•
A/B
, you should not make long
SAT
key repeatedly. Satellites and their corre-
19
TechniSat EC 4004
, "F" is re-displayed.
Advertisement
Table of Contents
