Switching On And Off; Channel Selection - TechniSat DigiCorder HD series Short Instructions

Position A/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position A/Option B and confi rm by pressing OK.
Position B/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position B/Option B and confi rm by pressing OK.
In the next step, you should check on the correct confi guration of your
antenna.
> If you wish to accept the settings entered, use the arrow keys up/down
to highlight the fi eld Yes, and confi rm by pressing OK.
You can abort the initial installation at any time simply by pressing the red func-
tion key. Press the green function key to go back to the previous step in the
installation procedure. Thus any entries made incorrectly can be quickly cor-
rected. If you do not implement the initial installation, or if it is not completed,
the receiver will commence operation with a standard pre-channeld confi gura-
tion.
For daily use

Switching on and off

> Press the On/Standby key either on the digital receiver or the remote
control to switch the receiver on.
> Press the same key again to switch the receiver off.

Channel selection

Using the channel up/down keys
> Use the channel up/down keys on the remote control or on the receiver
to move up or down the list one channel slot at a time.
Using the numeric keys
> You may use the numeric keys to enter the desired channel number. For
example: 1 for channel 1
1, then 4 for channel 14
2, then 3, then 4 for channel 234
When entering a channel number consisting of several digits, you have ap-
prox. 3 seconds after pressing each number to complete the entry. If you wish
to enter a number consisting of only one or two digits, you can speed up the
switching procedure by holding the key down on the last digit.
9