Legal Information - Otto Bock 12S4 Instructions For Use Manual

shoulder support in order to achieve secure force transmission between
the outer socket and modular arm component (Fig. 13). In the area of
the fixing holes, use the 507S15 Steel Washer with hole.
4) Once the laminate of the outer socket has cured, laminate the cap for
later attachment of the cosmetic foam cover. This will allow easy dis-
assembly of the cosmetic foam cover when changing the friction setting
on the Ottobock Shoulder Joint. For this purpose, pull three layers of
623T3=* Perlon Stockinette over the outer socket, which serve as spacer
between the outer socket and cap.
5) Lay a PVA bag over the Perlon Stockinette for laminating the cap onto.
Again, use 616G12 Carbon Fibre Cloth and the 507S15 Steel Washer
with hole for better force transmission (Fig. 14).
6) Once the laminate has cured, drill the required fixing holes between the
outer socket and inner socket. Then remove the inner socket and the
shaped foam part. Next, drill the bore holes through the outer socket
and cap.
7) In the area of the joint connection, remove the lamination ring or shoulder
support from the laminate (Fig. 15). Create the outer shape of the outer
socket and cap by cutting and grinding (Fig. 16).
Subsequently, assemble the outer socket, cap and shoulder joint.
4.3 Adjustments and final assembly
12S4
The T-screw (Fig. 3; item 1) is used to adjust the friction of anteversion
and retroversion movement. Adjust it on the inner side of the outer socket.
2S7
Change the movement friction setting by adjusting the clamp of the ball on
the 501Z2=M4x18 Cap Screw (Fig. 12; item 1).

5 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
Ottobock | 17