Table of Contents
Advertisement
im Vertrieb von
Matrix IP Address field
Extron Name/Descriptor field
www.camboard.de
CAMBOARD Electronics
Editing variables on the IP Settings/Options screen while connected via the
Ethernet port can immediately disconnect the user from the switcher. Extron
recommends editing the settings on this screen using the RS-232 link and
protecting the Ethernet access to this screen by assigning an administrator's
password to qualified and knowledgeable personnel only.
When the control program is connected to the switcher via the RS-232 link, the
Administrator and User Password fields are not masked. If a password has
been inadvertently changed to an unknown value, you can look up and, if
desired, change a password in this window without knowing the current
password.
The Matrix IP Address field contains the IP address of the connected matrix
switcher. This value is encoded in the flash memory in the switcher.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by
dots (periods). Each field can be numbered from 000 through 255. Leading zeroes,
up to 3 digits total per field, are optional. Values of 256 and above are invalid.
The default address is 192.168.254.254, but if this conflicts with other equipment at
your installation, you can change the IP address to any valid value.
Editing the Extron IP address while connected via the Ethernet port can
immediately disconnect the user from the matrix switcher. Extron
recommends editing this field using the RS-232/RS-422 link and protecting
the Ethernet access to this screen by assigning an administrator's password to
qualified and knowledgeable personnel only.
Edit this field as follows:
1.
Click in the Matrix IP address field. The graphic cursor becomes a text cursor.
2.
Edit the address as desired.
3.
Press the Tab key on the keyboard or click in another field to exit the Matrix IP
Address field.
4.
Click on the Take button to make the address change take affect.
The Extron Name/Descriptor field contains the name used as the "from"
information when the CrossPoint 450 Plus or MAV Plus switcher e-mails
notification of its failed or repaired status. This descriptor can be changed to any
valid name, up to 12 alphanumeric characters.
The following characters are invalid in the Extron Name/Descriptor field:
{space} + ~ , @ = ' [ ] { } < > ' " ; : | \ and ?.
Edit this field as follows:
1.
Click in the Extron name/descriptor field. The graphic cursor becomes a text
cursor.
2.
Edit the name as desired.
3.
Press the Tab key on the keyboard or click in another field to exit the Extron
Name/Descriptor field.
4.
Click on the Take button to make the name change take effect.
Tel. 07131 911201
CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
Fax 07131 911203
ce-info@camboard.de
5-7
Advertisement
Table of Contents
