Table of Contents
Advertisement
im Vertrieb von
File Management Page
www.camboard.de
CAMBOARD Electronics
2.
Connect the PC to the CrossPoint 450 Plus or MAV Plus switcher via the
switcher's Ethernet port.
3.
Access the CrossPoint 450 Plus or MAV Plus switcher using HTML pages.
4.
Click the Configuration tab.
5.
Click the Firmware Upgrade link.
6.
Click the Browse button. An open file window appears.
7.
Navigate to the folder where you saved the firmware upgrade file. Select the
file.
Valid firmware files must have the file extension '.S19'. Any other file
extension is not a firmware upgrade.
The original factory-installed firmware is permanently available on the
CrossPoint 450 Plus or MAV Plus switcher. If the attempted firmware upload
fails for any reason, the switcher automatically reverts to the factory-installed
firmware.
8.
Click the Open button.
9.
Click the Upload button. The firmware upload to the CrossPoint 450 Plus or
MAV Plus switcher may take a few minutes.
To delete files such as HTML pages from the switcher or to upload your own files
to the switcher, click the File Management tab. The switcher downloads the file
management HTML page (figure 6-9).
Refresh.
Figure 6-9 — File Management page
The files listed in figure 6-9 are shown for example only and may not be
present on your switcher.
To delete a file, check the associated delete check box and click the Delete Files
button.
Tel. 07131 911201
CrossPoint 450 Plus and MAV Plus Switchers • HTML Operation
Fax 07131 911203
ce-info@camboard.de
6-11
Advertisement
Table of Contents
