Table of Contents
Advertisement
Matrix Software, cont'd
IP Settings/Options window
The IP Settings/Options window (figure 5-7), accessible via the Tools menu,
provides a location for viewing and, if connected via either serial port or if logged
on via the Ethernet port as an administrator, editing settings unique to the Ethernet
interface. See appendix A, "Ethernet Connection", for basic information about
IP addresses. None of the fields on this screen can be edited while you are logged
on as a user.
Figure 5-7 — Control program IP Setting/Options window
N Editing variables in the IP Settings/Options window while connected via the
N When the control program is connected to the switcher via the RS-232 link, the
Matrix IP Address field
The Matrix IP Address field contains the IP address of the connected matrix
switcher. This value is encoded in the flash memory in the switcher.
Standard IP protocol consists of addresses comprised of four 1-, 2-, or 3-digit
numeric subfields, properly called octets, separated by dots (periods). Each field
can be numbered from 000 through 255. Leading zeroes, up to 3 digits total per
field, are optional. Values of 256 and above are invalid.
The default address is 192.168.254.254, but if this conflicts with other equipment at
your installation, you can change the IP address to any valid value.
N The Matrix IP Address field is grayed out and uneditable when DHCP is
5-8
Fiber Matrix 6400 Switcher • Matrix Software
Ethernet port can immediately disconnect the user from the switcher. Extron
recommends editing the settings on this screen using the RS-232 link and
protecting the Ethernet access to this screen by assigning an administrator's
password to qualified and knowledgeable personnel only.
Administrator and User Password fields are not masked. If a password has been
inadvertently changed to an unknown value, you can look up and, if desired,
change a password in this window without knowing the current password.
selected.
Advertisement
Table of Contents
