Matrix Ip Address Field; Extron Name/Descriptor Field - Extron electronics CrossPoint 450 Plus Series User Manual

Matrix Software, cont'd

Matrix IP Address field

The Matrix IP Address field contains the IP address of the connected matrix
switcher. This value is encoded in the flash memory in the switcher.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by
dots (periods). Each field can be numbered from 000 through 255. Leading zeroes,
up to 3 digits total per field, are optional. Values of 256 and above are invalid.
The default address is 192.168.254.254, but if this conflicts with other equipment at
your installation, you can change the IP address to any valid value.
Edit this field as follows:
1.
2.
3.
4.

Extron Name/Descriptor field

The Extron Name/Descriptor field contains the name used as the "from"
information when the CrossPoint 450 Plus or MAV Plus switcher e-mails
notification of its failed or repaired status. This descriptor can be changed to any
valid name, up to 12 alphanumeric characters.
Edit this field as follows:
1.
2.
3.
4.
5-8 CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
Editing the Extron IP address while connected via the Ethernet port can
immediately disconnect the user from the matrix switcher. Extron
recommends editing this field using a serial port and protecting the Ethernet
access to this screen by assigning an administrator's password to qualified and
knowledgeable personnel only.
Click in the Matrix IP address field. The graphic cursor becomes a text cursor.
Edit the address as desired.
Press the Tab key on the keyboard or click in another field to exit the Matrix IP
Address field.
Click on the Take button to make the address change take affect.
The following characters are invalid in the Extron Name/Descriptor field:
{space} + ~ , @ = ' [ ] { } < > ' " ; : | \ and ?.
Click in the Extron name/descriptor field. The graphic cursor becomes a text
cursor.
Edit the name as desired.
Press the Tab key on the keyboard or click in another field to exit the Extron
Name/Descriptor field.
Click on the Take button to make the name change take effect.