Bwx 8305 Basestation Installation - Cisco BWX 8305 Installation And Commissioning Manual

Table of Contents

Advertisement

Chapter 6
Installation

6.4 BWX 8305 Basestation Installation

6.4.1 Overview
The BS is a lightweight unit that fits easily into standard Telecom racks. All connectors and indicators
on the BS are on the faceplate
two cards inside the BS are not field replaceable. Therefore, if a severe Fault occurs, the entire unit is
removed and replaced. The design intent is to cut down on the time it takes to troubleshoot or otherwise
have a field support person onsite.
Figure 6-24
The Console Port, Ethernet Port, 8 RF Ports, Cal Port, GPS Port, Power, and Grounding connectors are
located on the faceplate. There are also five LED indicators at the top middle of the faceplate.
At no time should a field person remove the back of the unit or otherwise open it. In fact, doing so
may void the warranty.
Cisco recommends 5% spares planning for BS.
OL-16336-02
(Figure
BWX 8305 Basestation Faceplate
2 Ethernet Ports
2 Ethernet Ports
Console
Console
Data
Data
Port
Port
RF Ports
RF Ports
8–5
8–5
+24 VDC/40A
+24 VDC/40A
Power Input
Power Input
On/Off
On/Off
(Also available:
(Also available:
Switch
Switch
-48 VDC/30A and
-48 VDC/30A and
100-240VAC/50-60 Hz/10A)
100-240VAC/50-60 Hz/10A)
The Power indicator is lit when the power is on.
The Booting indicator flashes when the system is booting up, and it turns off when booting is
complete. The middle light, the Fault indicator, will flash red if there is a hardware fault, such as
operating temperature out of range or an antenna path is not functioning.
The RF indicator indicates that one or more RF antenna paths are turned on and radiating energy.
Lastly, the GPS Lock indicator on the far right is lit to indicate that the BS is locked to its timing
source - the BWX 8303 Basestation Timing System.
6-24). Inside the unit are two cards: Digital and RF. Note that the
Power
Power
MGMT
MGMT
(not used at
(not used at
this time)
this time)
CAL
CAL
10 MHz
10 MHz
10 MHz
1 PPS
1 PPS
1 PPS
Port
Port
External Precise
External Precise
External Precise
Clocking Source
Clocking Source
Clocking Source
BWX 2305 Basestation Installation and Commissioning Guide
BWX 8305 Basestation Installation
5 LEDs
5 LEDs
Fault
Fault
Booting
Booting
RF
RF
GPS
GPS
Grounding
Grounding
Lug
Lug
RF Ports 4–1
RF Ports 4–1
6-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents