Chapter 1 Safety - Cisco BWX 8305 Installation And Commissioning Manual

Information to User
7.
8.
9.
10.
11.
12.
13.
Warning The BS is a Radio Frequency transmitter. It is required to comply with FCC and local country RF
exposure requirements for transmitting devices. A minimum separation distance of 2 meters or more
must be maintained between the antenna and all persons during device operations to ensure
compliance with the FCC's and the local country's rules for Radio Frequency Exposure. If this minimum
distance cannot be maintained, exposure to RF levels that exceed the FCC's and the local country's
limits may result.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
Note
to part 15 of the FCC Rules and local country rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Information to User
The BS has been authorized as a radio frequency transmitter under the appropriate rules of the Federal
Communications Commission. Any changes or modifications not expressly approved by Cisco could
void the user's authority to operate the equipment.
BWX 8305 Basestation Installation and Commissioning Guide
1-2
Do not use a frayed or damaged power cord. Do not place the power cord where it can be stepped
on or tripped over.
Do not touch wires where the insulation is frayed or worn unless the equipment has been
disconnected from its power source.
Do not overload wall outlets, power strips, or extension cords. This can cause serious electrical
shock or fire.
Do not place the equipment on an unstable surface. It can fall and cause injury or damage to the
equipment.
Do not disassemble the equipment. Removing covers exposes dangerous voltages or other risks and
also voids the warranty. Incorrect reassembly can cause equipment damage or electrical shock. Only
an authorized repair technician should service this product.
Do not expose the equipment to extreme hot or cold temperatures.
Do not use the equipment under the following conditions:
When the equipment has been exposed to water or moisture.
–
When the equipment has been damaged.
–
When the power cord is damaged or frayed.
–
When the equipment does not operate properly or shows a distinct change in performance.
–
Chapter 1 Safety
OL-16336-02