Cisco BWX 8305 Installation And Commissioning Manual page 71

Chapter 6 Installation
Step 16 Verify the status of the BWX 8303 Basestation Timing System, by typing the following command: status
(Refer to
The initial boot-up with a 2000 position average may take 30 - 40 minutes to complete. It will be
Note
necessary to enter the status command several times to monitor the progress. Once the Unit Mode field
changes to Calculating Position monitor the Positioning count field for progress.
Example 6-3
> status
PTF 3203A GPS receiver Software Version 2.27-2c, CPLD Version 10
Capabilities -> Normal + SNTP + SNMP + HTTP + TELNET
Unit Mode
Satellites tracked
Positioning count
Latitude (*1E6)
Longitude (*1E6)
Height (cm)
Ethernet Link status
Started SNTP Server
Started SNMP Server
Started HTTP Server
Started Telnet Server
Telnet session active
>
>
>
> status
PTF 3203A GPS receiver Software Version 2.27-2c, CPLD Version 10
Capabilities -> Normal + SNTP + SNMP + HTTP + TELNET
Unit Mode
Satellites tracked
Positioning count
Latitude (*1E6)
Longitude (*1E6)
Height (cm)
Ethernet Link status
Started SNTP Server
Started SNMP Server
Started HTTP Server
Started Telnet Server
Telnet session active
>
>
>
> status
PTF 3203A GPS receiver Software Version 2.27-2c, CPLD Version 10
Capabilities -> Normal + SNTP + SNMP + HTTP + TELNET
Unit Mode
Satellites tracked
OL-16336-02
Example 6-3)
BWX 8303 Basestation Timing System Status Output
Oven warmup
00
0
22281322
114175000
12394
UP
NO
NO
NO
NO
NO
Calculating Position
04
35
22280838
114174968
11222
DOWN
NO
NO
NO
NO
NO
Calculating Position
04
Connect BWX 8303 Basestation Timing System
BWX 2305 Basestation Installation and Commissioning Guide
6-35