Verifying The Installation - Cisco 6500-E Installation And Verification Manual

Communication media module for catalyst 6500 series switch and cisco 7600 series router
Hide thumbs Also See for 6500-E:
Table of Contents

Advertisement

Using the screws or standoffs to seat the port adapter could warp the port adapter. Before you install and
Caution
tighten the securing screws, ensure that the port adapter is fully seated by visually verifying that the
bottom of the port adapter is in contact with the top of the mounting posts.
Install the two standoffs and two Phillips screws to secure the port adapter. (See
Step 6
Install the module into the Catalyst 6500 series switch or Cisco 7600 series router; see the
Step 7
the Module" section on page

Verifying the Installation

Enter the show module mod-num command to verify that the system acknowledges the new module and
has brought it online.
This example shows the output of the show module command with a module in slot 4:
Console> (enable) show module 4
Mod Slot Ports Module-Type
--- ---- ----- ------------------------- ------------------- --- --------
4
Mod Module-Name
--- -------------------- -----------
4
Mod MAC-Address(es)
--- -------------------------------------- ------ ---------- -----------------
4
RJ-45 Port Connector and Cabling Specifications
Warning
Before opening the unit, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. Statement 1041
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Never install telephone jacks in wet locations unless the jack is specifically designed for
Warning
wet locations. Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been
Warning
disconnected at the network interface. Statement 1037
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
10.
4
5
Communication Media Mod.
Serial-Num
sad054206jc
00-01-64-46-6a-0e to 00-01-64-46-6a-17 1.0
Model
Sub Status
WS-SVC-CMM
no
Hw
Fw
Sw
12.2(2002012.2(20020530:100440
Verifying the Installation
Figure
12.)
"Installing
ok
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents