Cisco BWX 8305 Installation And Commissioning Manual page 30

Cut-Over
4.6 Cut-Over
BWX 8305 Basestation Installation and Commissioning Guide
4-6
Cut-Over
D D
In the Test EMS, In the Test EMS, In the Test EMS,
export the BS record export the BS record export the BS record
(BTS Data Export) (BTS Data Export) (BTS Data Export)
Copy this Copy this Copy this
BTS Data Export record BTS Data Export record BTS Data Export record
ton the computer where the ton the computer where the ton the computer where the
Production EMS was installed Production EMS was installed Production EMS was installed
In the Production EMS, In the Production EMS, In the Production EMS,
import the BS record import the BS record import the BS record
(BTS Data Import) (BTS Data Import) (BTS Data Import)
Edit the BS record Edit the BS record Edit the BS record
(Change the EMS IP, BTS IP, (Change the EMS IP, BTS IP, (Change the EMS IP, BTS IP,
subnet mask, and gateway IP subnet mask, and gateway IP subnet mask, and gateway IP
to the correct value for the to the correct value for the to the correct value for the
Production EMS) Production EMS) Production EMS)
Chapter 4
Connect the Data port of the BS Connect the Data port of the BS Connect the Data port of the BS Connect the Data port of the BS
directly to the Ethernet backhaul directly to the Ethernet backhaul directly to the Ethernet backhaul directly to the Ethernet backhaul
Connect the console port of the BS Connect the console port of the BS Connect the console port of the BS Connect the console port of the BS
to the serial port of the Installer's to the serial port of the Installer's to the serial port of the Installer's to the serial port of the Installer's
laptop and start a Terminal laptop and start a Terminal laptop and start a Terminal laptop and start a Terminal
Emulation window Emulation window Emulation window Emulation window
Power up the BS. Power up the BS. Power up the BS. Power up the BS.
Change the boot-line parameters Change the boot-line parameters Change the boot-line parameters Change the boot-line parameters
to point to the BS record in the to point to the BS record in the to point to the BS record in the to point to the BS record in the
Production EMS. Production EMS. Production EMS. Production EMS.
Resume the boot Resume the boot Resume the boot Resume the boot
From the Production EMS, From the Production EMS, From the Production EMS, From the Production EMS,
Calibrate the BS Calibrate the BS Calibrate the BS Calibrate the BS
Backup the Production EMS Backup the Production EMS Backup the Production EMS Backup the Production EMS
End End End
I&C Process
OL-16336-02