Draining Product From The Freezing Cylinder; Rinsing - Taylor 8756 Operator's Manual

Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO and MIX REF keys to cancel
freezer operation.
Step 2
Open the mix cabinet door and remove the mix
storage cover, the mix tank cover, the mix tank, and
the mix probe.
Step 3
If local health codes permit the use of rerun,
empty the mix from the mix tank into a sanitized,
NSF approved stainless steel rerun container. Place
a sanitized lid on the rerun container and place it in
the walk-in cooler.
Note: If local health codes DO NOT permit the
use of rerun, the product must be discarded.
Step 4
Place the suction line in an empty pail in the mix
cabinet.
Repeat these steps for the second freezing
cylinder.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Model 8756

Rinsing

Step 1
Fill the empty pail in the mix cabinet with two gallons
(7.6 liters) of cool, clean water. Place the free end
of the suction line in the pail of water.
Step 2
Disconnect the pressure line from the pressure
switch and place it in the pail of water.
Step 3
Press the PUMP key. This action will cause the
rinse water to be pumped through the air/mix pump
and out through the pressure line. After
approximately 15 seconds, press the PUMP key to
stop operation.
Step 4
Drain and connect the free end of the pressure line
to the pressure switch.
29
Figure 62
Operating Procedures