Draining Product From The Freezing Cylinder; Rinsing - Taylor 8752 Operating Instructions Manual

Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO and MIX REF keys to cancel freezer
operation.
Step 2
Open the mix cabinet door and remove the mix storage
cover(s), mix tank cover(s), mix tank(s), and mix
probe(s). Empty the mix from the mix tank(s) into a
sanitized stainless steel rerun can.
Step 3
Place the suction line in an empty pail in the mix
cabinet.
Step 4
If local health codes permit the use of rerun, place
a sanitized, NSF approved stainless steel rerun
container beneath the door spout.
Open the draw valve and press the WASH
S
and PUMP keys.
Drain all the mix from the freezing cylinder.
S
When all the product stops flowing from the
S
door spout, close the draw valve and press
the WASH and PUMP keys to stop
operation.
Place a sanitized lid on the rerun container
S
and place it in the walk--in cooler.
Note: If local health codes DO NOT permit the use
of rerun, the product must be discarded. Follow the
instructions in the previous step, except drain the
product into a mix pail and properly discard the mix.
Repeat Steps 3 through 4 for the second freezing
cylinder on the Model 8756.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Models 8752 & 8756 with Horizon® Pump

Rinsing

Step 1
Fill the empty pail in the mix cabinet with 2 gallons (7.6
liters) of cool, clean water. Place the free end of the
suction line in the pail of water.
Step 2
Disconnect the pressure line from the check valve and
place it in the pail of water.
Step 3
Press the PUMP key. This action will cause the rinse
water to be pumped through the Horizon® pump and
out through the pressure line. After approximately 15
seconds, press the PUMP key to stop operation.
Step 4
Drain and connect the free end of the pressure line to
the check valve.
31
Figure 59
Figure 60
Operating Procedures