Operating Procedures; Assembly - Taylor 8756 Operator's Manual

Section 6
The Model 8756 has two freezing cylinders. The size
of each freezing cylinder is 3.4 quarts (3.2 liters).
Mix is stored in the lower front refrigerated
compartment and is pumped up to the freezing
cylinder by an air/mix pump.
Duplicate the following procedures, where they
apply, for the second freezing cylinder.
We begin our instructions at the point where we
enter the store in the morning and find the parts laid
out to air dry from the previous night's brush
cleaning.
If you are disassembling the machine for the first
time, or need information to get to this starting point
in our instructions, turn to page 31, "Disassembly"
and start there.

Assembly

MAKE SURE THE POWER SWITCH IS IN
THE "OFF" POSITION. Failure to follow this
instruction may result in electrocution or injury to
fingers or hands from hazardous moving parts.
Step 1
Lubricate the groove and shaft portion that comes in
contact with the bearing on the beater drive shaft.
Slide the seal over the shaft and groove until it
snaps into place. DO NOT lubricate the hex end of
the drive shaft. Fill the inside portion of the seal
with1/4" more lubricant and evenly lubricate the end
of the seal that fits onto the rear shell bearing.

Operating Procedures

Operating Procedures
Note: For ease of cleaning, the seal may be turned
inside out. Be sure to position the seal correctly
during assembly.
16
Figure 6
Figure 7
Model 8756