Closing Procedure - Taylor 8756 Operator's Manual

Step 7
When a steady stream of mix is flowing from the
prime plug hole in the bottom of the freezer door,
press the PUMP key to stop operation.
Figure 59
Step 8
Once the stream of mix stops flowing from the prime
plug hole, push down the prime plug. Rinse the
prime plug hole area with water. Remove the pail
and discard the mix and sanitizer.
Figure 60
Step 9
Press the AUTO key. The MIX REF indicator will
illuminate to indicate the mix refrigeration system is
operating. The AUTO indicator will illuminate to
indicate that the main refrigeration system is
operating. The PUMP indicator will illuminate to
indicate that the air/mix pump will operate whenever
mix is needed in the freezing cylinder.
Operating Procedures
Repeat these steps for the other side of the
freezer.
When the unit cycles off, the product will be at the
correct viscosity.
Note: Keep the mix cabinet door closed except
when filling the mix tank and during cleaning and
sanitizing procedures. Leaving the door open while
the mix refrigeration system is active may cause the
evaporator to ice up and impair the mix cabinet
refrigeration.

Closing Procedure

To disassemble the Model 8756, the following items
will be needed:
S
Two cleaning and sanitizing pails
S
Necessary brushes (provided with freezer)
S
Cleaner
S
Single service towels
28
Figure 61
Model 8756